Filter
Top Products
EN Alphabetical messages 55
1
The maximum number of characters that can be used is 60. If you have
a number longer than 60 characters, break the number into smaller
chunks.
1 Type the first part of the number, and then press R
EDIAL/PAUSE as
the last character in the first number.
2 Type the second part of the number as if it were a second number
going to a group. When the product dials, it will treat both numbers
as if they are one.
Make sure that the sender’s fax machine is ready to be polled, and
check the fax number. Then, set up to poll again.
The product has detected a power failure and is performing a self-test.
1 The product should go back to the Ready state on its own. If this
message does not disappear in a couple of minutes, disconnect the
power cable from the product, wait at least 30 seconds, and then
reconnect the power cable.
2 Wait for the product to initialize.
Press S
TOP/CLEAR to clear the error. The product should return to the
Ready state.
The product has detected a power failure and is printing all of the faxes
that it did not previously print. Once the faxes are printed, the product
returns to the Ready state.
Phone number error
Polling-in error
Power fail recover/Checking system
Power fail recovery/Fax setting reset
Power fail recovery/Printing faxes