Filter
Top Products
Figure 6-11 DVD Drive Removal and Replacement
DVD Release
Hole
Front Chassis View
Replacing the DVD Drive
To replace a DVD drive, follow these steps:
1. Insert the DVD drive, and push it straight into the drive bay until it clicks into place
(Figure 6-11).
2. Reconnect the power cables and power on the server. See “Powering On the Server”
(page 94).
Removing and Replacing the Memory Carrier Assembly
The memory carrier assembly encloses the system DIMMs. There are two different memory
carrier assemblies available for this server:
• 8-DIMM memory carrier assembly
• 24-DIMM memory carrier assembly
The 8- and 24-DIMM memory carrier assemblies have two sides, 0 and 1, each of which contain
a memory board. System DIMMs seat onto the memory boards.
Table 6-4 lists the supported memory carrier assembly configurations.
Table 6-4 Supported Memory Carrier Assembly Configurations
Memory Boards InstalledMemory Carrier Configuration
Two 4-DIMM memory boards8-DIMM memory carrier
Two 12-DIMM memory boards24-DIMM memory carrier
Removing and Replacing the Memory Carrier Assembly 203