Filter
Top Products
NOTE: The USB cable connector is an RJ45 connector; it is not a typical USB connector.
4. Remove the air baffle (Figure 6-33).
5. Remove the clear plastic cover.
6. Disconnect the USB cable from the connector on the display board (Figure 6-30).
7. Remove the DVD drive. See “Removing the DVD Drive” (page 202).
8. Locate the knurled thumbscrew behind the DVD drive that holds the display board in place
(Figure 6-30).
9. Turn the thumbscrew counterclockwise until the board releases from the chassis.
10. Remove the top two screws from the right side of the bezel. Pull the bezel out from the
chassis approximately one half inch so that the display board can clear the locator and power
buttons (Figure 6-30).
CAUTION: Do not pull the bezel out from the chassis more than one half inch. Do not use
the USB connector as a handle to remove the display board. Failure to observe these cautions
can result in damage to server components.
11. Hold the bezel out from the chassis, and use the diagnostic panel light guide as a handle to
simultaneously push the board to the left to unplug it from the socket on the interconnect
board.
NOTE: Use the guide pins on the chassis and the L-shaped keyways on the display board
to help you with the display board removal procedures.
12. Slide the board toward the rear of the chassis until it stops against the guide pins.
13. Tilt the board toward the front of the chassis, and lift it out at an angle.
Removing and Replacing the Display Board 243