Filter
Top Products
1 Overview
The HP Integrity rx3600 server is a high performance, high availability server that provides the
following features:
• Form factor - 4U rack- or pedestal-installed
• Internal peripherals - serial-attached SCSI (SAS) hard drives and a DVD or DVD+RW drive
• High availability components - N+1 hot-swappable fans, 1+1 hot-swappable power supplies,
and hot-pluggable PCI-X or PCIe cards and SAS drives
• Processors - one or two dual-core Intel® Itanium® processors
• Memory - up to 96 GB of memory
This chapter addresses the following topics:
• “Server Subsystems” (page 25)
— “I/O” (page 25)
— “Processor” (page 29)
— “Memory” (page 29)
— “Cooling” (page 31)
— “Power” (page 32)
— “Front Display Panel, DVD, and Diagnostic Panel” (page 34)
— “Mass Storage” (page 34)
• “Firmware” (page 35)
• “Controls, Ports, and LEDs” (page 36)
— “Front Panel” (page 36)
— “Storage and Media Devices” (page 38)
— “Diagnostic Panel” (page 39)
— “Rear Panel” (page 40)
Server Subsystems
I/O
The server may contain either a 10-slot PCI/PCI-X IOBP or a 10-slot PCI/PCI-X/PCIe IOBP. The
PCI/PCI-X/PCIe interfaces are classified under two major categories: public and private.
Public interfaces Public interfaces are PCI slot connectors that are left available to the customer
for the I/O-card adapters which they wish to install, based on their application needs, provided
the adapter is supported in the slot. All public slots support HP server traditional OL* hot-plug
operations.
Private interfaces Private interfaces are interfaces dedicated to meeting the core I/O system
requirements. There are two types of core-I/O: fast-core and slow-core, also known as the UCIO
(Unified Core-I/O). The Private slots and UCIO are not hot-pluggable.
Hot-plug PCI/PCI-X/PCIe hot-pluggable operations enable you to add or remove a
PCI/PCI-X/PCIe card while the server is powered on. Each slot is physically separated with a
divider that contains a card extraction mechanism and a mechanical retention latch (MRL). Slots
3 - 10 on the 10 slot PCI/PCI-X IOBP and slots 5 - 10 on the 10 slot PCI/PCI-X/PCIe IOBP support
HP-server traditional OL* "hot-plug" operations. PDHP slots rely on the facilities of DHPC (Dual
Hot-plug Controller) FPGAs to enable OL* hot-plug functionality. See Table 1-1 (page 27) and
Table 1-2 (page 28) for details.
LEDs Attention LEDs, doorbell buttons, and power LEDs for each hot-pluggable PCI/PCI-X/PCIe
slot are located on the PCI bulkhead at the rear of the server chassis.
Server Subsystems 25