Filter
Top Products
1. Unlatch the cover release lever on the top cover and remove the memory carrier assembly
cover. See “Removing the Memory Carrier Assembly Cover” (page 57).
NOTE: You do not need to fully remove the top cover to service this component; however,
the top cover release lever must be open.
2. Press the button located in the center of the memory carrier assembly to release the extraction
handles (Figure 3-7).
CAUTION: Manipulate the extraction handles with care. Failure to observe this caution
can result in damage to the extraction handles.
3. Pull up on the extraction handles and rotate them outward 90 degrees (Figure 3-7). The
handles latch into the open position with an audible click.
4. Lift the memory carrier assembly out of the chassis (Figure 3-7).
NOTE: To avoid damage to the handles, HP recommends rotating the handles inward and
snapping them into place when servicing the system DIMMs, or any time the carrier is out
of the chassis. Before replacing the memory carrier, press the button to release the extraction
handles. Use the handles to replace the memory carrier into the chassis.
Figure 3-7 Removing and Replacing the Memory Carrier Assembly
Replacing the Memory Carrier Assembly
CAUTION: Ensure that the processor board assembly is fully seated before you replace the
memory carrier assembly. The processor board assembly access door must be flush with the
front bezel.
To replace the memory carrier assembly, follow these steps:
1. Ensure the extraction handles are positioned in the outward, unlocked position.
2. Align the memory carrier assembly with the front and rear chassis guide slots.
66 Installing the System