HP (Hewlett-Packard) RX3600 Computer Accessories User Manual


 
NOTE: To avoid damage to the memory carrier extraction handles, HP recommends
rotating the handles inward and snapping them into the locked position when servicing the
system DIMMs or any time the carrier is out of the chassis. Before replacing the memory
carrier, press the button to release the extraction handles. Use the handles to replace the
memory carrier into the chassis.
5. Complete the following memory installation prerequisite tasks before installing the memory:
a. Determine the DIMM load order as appropriate for the 8-DIMM or 24-DIMM memory
carrier. For more information, see “Memory Load Order” (page 209).
b. Determine the DIMM slots to populate using Figure 6-15 (page 210) or Figure 6-16
(page 211)..
c. Read, understand, and follow the general guidelines to install memory in the server.
See “Memory Loading Rules and Guidelines” (page 211).
6. Lay the memory carrier assembly on side 0 or side 1 so that the memory carrier side that
contains the DIMM slots that require servicing faces upward (Figure 6-13).
7. Remove the memory carrier assembly side cover.
a. Press the release tabs (Figure 6-13) on both sides of the extraction handle release button
until the side cover releases from the top center of the assembly.
b. Rotate the side cover slightly to free the tabs from the retaining slots at the base of the
assembly (Figure 6-14).
c. Lift the side cover off the assembly.
Removing and Replacing the Memory Carrier Assembly 213