Filter
Top Products
Extensible Firmware Interface Specification
15-4 12/01/02 Version 1.10
MaxPacketSize The maximum size, in bytes, of the packets supported by the
network interface.
NvRamSize The size, in bytes, of the NVRAM device attached to the
network interface. If an NVRAM device is not attached to the
network interface, then this field will be zero. This value must
be a multiple of NvramAccessSize.
NvRamAccessSize The size that must be used for all NVRAM accesses. This
means that the start address for NVRAM read and write
operations, and the total length of those operations, must be a
multiple of this value. The legal values for this field are 0, 1, 2,
4, 8. If the value is zero, then no NVRAM devices are attached
to the network interface.
ReceiveFilterMask The multicast receive filter settings supported by the network
interface.
ReceiveFilterSetting The current multicast receive filter settings. See “Bit Mask
Values for ReceiveFilterSetting” below.
MaxMCastFilterCount The maximum number of multicast address receive filters
supported by the driver. If this value is zero, then the multicast
address receive filters cannot be modified with ReceiveFilters().
This field may be less than MAX_MCAST_FILTER_CNT (see
below).
MCastFilterCount The current number of multicast address receive filters.
MCastFilter Array containing the addresses of the current multicast address
receive filters.
CurrentAddress The current HW MAC address for the network interface.
BroadcastAddress The current HW MAC address for broadcast packets.
PermanentAddress The permanent HW MAC address for the network interface.
IfType The interface type of the network interface. See RFC 1700,
section “Number Hardware Type.”
MacAddressChangeable TRUE if the HW MAC address can be changed.
MultipleTxSupported TRUE if the network interface can transmit more than one packet
at a time.
MediaPresentSupported TRUE if the presence of media can be determined; otherwise
FALSE. If FALSE, MediaPresent cannot be used.
MediaPresent TRUE if media are connected to the network interface; otherwise
FALSE. This field is only valid immediately after calling
Initialize()
.