Filter
Top Products
6 Press .
7 To change the number of times the printer will redial:
a Press or repeatedly until Redial Attempts appears.
b Press .
c Press or repeatedly until the setting you want appears.
d Press .
8 To change the length of time between redials:
a Press or repeatedly until Redial Time appears.
b Press .
c Press or repeatedly until the setting you want appears.
d Press .
Schedule to resend fax at a later time
See “Sending a broadcast fax at a scheduled time” on page 115.
Failed to Connect
These are possible causes and solutions. Try one or more of the following:
Use phone line checklist
• Resend the fax. There may have been a problem with the quality of the telephone line connection.
• Place a test call to the telephone number to which you want to send a fax to make sure that it is working correctly.
• If the telephone line is being used by another device, wait until the other device is finished before sending the
fax.
Make sure the printer detects dial tone
• See “Sending a fax while listening to a call (On Hook Dial)” on page 115.
• Check the Dial Method setting.
1 Listen for a dial tone. If you hear a dial tone, but the printer hangs up without dialing, this means it did not
recognize the dial tone.
2 From the control panel, press Fax Mode.
3 Press .
4 Press or repeatedly until Fax Setup appears.
5 Press .
6 Press or repeatedly until Dialing and Sending appears.
7 Press .
8 Press or repeatedly until Dial Method appears.
9 Press .
10 Press or repeatedly until the method you want appears.
11 Press to save this setting.
190