Filter
Top Products
3-64 MAX 6000/3000 Network Configuration Guide
Configuring WAN Access
Configuring inbound calls
4 Set the DNIS #N Max Calls parameter to specify the total number of simultaneous V.110,
HDLC, and modem calls to the called number specified by DNIS #N.
Note: You must set the DNIS #N Max Calls parameter even if you configure the unit to
limit calls on the basis of modem, V.110, or HDLC calls.
5 Set DNIS #N Max Modem if you want to limit the number of simultaneous modem calls
to the called number specified by DNIS #N.
6 Set DNIS #N Max HDLC if you want to limit the number of simultaneous synchronous
calls to the called number specified by DNIS #N.
7 Set DNIS #N Max V110 if you want to limit the number of simultaneous V.110 calls to the
called number specified by DNIS #N.
8 Exit the profile and, at the exit prompt, select the exit and accept option.
You can configure up to sixteen DNIS numbers with unique limiting configurations for each
DNIS number.
Limiting calls to unspecified dialed numbers
As with specified dialed numbers, you can limit the number of simultaneous modem, HDLC,
or V.110 calls. Open the Ethernet > Mod Config > DNIS Options profile, and set the following
parameters:
1 Set DNIS Limitation to Yes.
2 Set the Unspecified Max Calls parameter if you want to limit the total of simultaneous
V.110, HDLC, and modem calls to called numbers that do not match any specified by
DNIS #N.
Note: You must set Unspecified Max Calls even if you configure the unit to limit calls on
the basis of modem, V.110, or HDLC calls.
3 Set the Unspecified Max Modem parameter if you want to limit the number of
simultaneous modem calls to called numbers that do not match any specified by DNIS #N.
4 Set the Unspecified Max HDLC parameter if you want to limit the number of
simultaneous synchronous calls to called numbers that do not match any specified by
DNIS #N.
5 Set the Unspecified Max V110 parameter if you want to limit the number of simultaneous
V.110 calls to called numbers that do not match any specified by DNIS #N.
6 Exit the profile and, at the exit prompt, select the exit and accept option.
Examples of call routing
This section shows three sample configurations that limit incoming calls on the basis of DNIS
values.
Limiting all modem calls that do not specify a DNIS number
To specify that the MAX unit accepts ten simultaneous modem calls that do not specify a
DNIS number, set the following parameters as shown:
• Unspecified Max Calls=10
• Unspecified Max Modem=10