Filter
Top Products
Configuring IPX Routing
Configuring IPX routing connections
MAX 6000/3000 Network Configuration Guide 12-13
PPP options...
Route IPX=Yes
Recv Auth=Either
5 Exit the profile and, at the exit prompt, select the exit and accept option.
6 Open the Connection profile you will use to configure the dial-in user’s connection.
7 Set the Station parameter to specify the dial-in client’s login name, and activate the profile
by setting Active to Yes. For example:
Ethernet
Connections
Connection profile
Station=scottpc
Active=Yes
8 Enable IPX routing:
Route IPX=Yes
9 Select PPP encapsulation and configure the dial-in client’s password. For example:
Encaps=PPP
Encaps options...
Recv PW=scottpw
10 Open the IPX Options subprofile and specify a dial-in client:
IPX options...
Peer=Dialin
IPX RIP=None
11 Exit the profile and, at the exit prompt, select the exit and accept option.
Following is a RADIUS profile comparable to the previous Connection profile:
scottpc Password = "scottpw"
Service-Type = Framed-User,
Framed-Protocol = MPP,
Ascend-Route-IPX = Route-IPX-Yes,
Ascend-IPX-Peer-Mode = IPX-Peer-Dialin
Configuring a connection between two LANs
In this example, the MAX unit connects to an IPX network that supports both servers and
clients and connects with a remote site that also supports both servers and clients, as shown in
Figure 12-2.