Filter
Top Products
3-84 MAX 6000/3000 Network Configuration Guide
Configuring WAN Access
Configuring MAXDAX
System
Answer Plan
Site C
Name=Site C
Answer #=6175551212
Answer Data Svc=
Dest ChanGroup=1
Dial Plan #=12
MAX 2 makes a call on the first available channel assigned to destination channel-group 1,
using Dial Plan profile 12. Because the system administrator leaves Answer Data Svc blank,
MAX 2 ignores the data service of the incoming call, and matches on the basis of called
number only.
Because the system administrator sets Dest ChanGroup to 1 in the Answer Plan profile, at least
one channel of the PRI line must belong to channel group 1. The system administrator
configures the line as follows:
Net/T1
Line Config
Line Config profile
Line 2...
Net2Net ChanGroup ID
Ch 1=Switched
Ch 1 ChanGroup=1
Ch 2=Switched
Ch 2 ChanGroup=1
The system administrator can assign more channels to channel group 1 if users, connected to
the PBX, require outbound dialing on the PRI line.
The Answer Plan profile also specifies that MAX 2 is to use Dial Plan profile 12 to make the
outbound call. The system administrator configures Dial Plan profile 12 as follows:
System
Dial Plan
PRI plan
Name=PRI plan
Call-by-Call=6
Data Svc=64K
PRI # Type=National
NumPlanID=ISDN
Transit #=
Bill #=
Dest #=
PrependDigits=
Because the system administrator leaves Dest # and PrependDigits blank, MAX 2 makes the
outbound call by using the called number from the incoming call.