Filter
Top Products
5-26 Preliminary January 4, 2001 MAX 6000/3000 Network Configuration Guide
Configuring Frame Relay
Configuring the MAX as a Frame Relay switch
Settings in a RADIUS profile
Following are the RADIUS attributes for configuring a Frame Relay circuit:
Examples of a circuit between UNI interfaces
Figure 5-10 shows a circuit configuration using UNI-DCE interfaces in the MAX.
Figure 5-10. Frame Relay circuit with UNI interfaces
Using local profiles
The following parameters on the MAX define the datalinks to the MAX and to the Pipeline
130 (P130-East):
Ethernet
Frame Relay
max
Name=max
Active=Yes
FR Type=DCE
FR Circuit Circuit name (up to 16 characters). The other endpoint must
specify the same circuit name. If only one profile specifies a
circuit name, data received on the specified DLCI is dropped. If
more than two profiles specify the same circuit name, only two of
the profiles will be used to form a circuit.
Parameter Specifies
Attribute Value
Framed-Protocol (7) Encapsulation protocol. Both endpoints of a circuit must specify
FR-CIR (263) encapsulation.
Ascend-FR-Profile-
Name (180)
Name of the Frame-Relay profile that defines the datalink.
Ascend-FR-DLCI (179) A DLCI for this PVC endpoint. The MAX does not allow you to
enter duplicate DLCIs, except when they are carried by separate
physical links specified in different Frame-Relay profiles.
Ascend-FR-Circuit-
Name (156)
Circuit name (up to 16 characters). The other endpoint must
specify the same circuit name. If only one profile specifies a
circuit name, data received on the specified DLCI is dropped. If
more than two profiles specify the same circuit name, only two of
the profiles will be used to form a circuit.
DTE DCE
DLCI 100
P130-West
DTE DCE
DCE DTE
DLCI 200
P130-East
MAX