Filter
Top Products
5-20 Preliminary January 4, 2001 MAX 6000/3000 Network Configuration Guide
Configuring Frame Relay
Concentrating incoming calls onto Frame Relay
Routing parameters in RADIUS
In addition to the attributes described in “Overview of DLCI interface settings” on page 5-13,
the following attribute-value pairs must be specified in the permconn profile of a Frame Relay
gateway:
Examples of a gateway configuration
In the following example, the MAX acts as a gateway between a client that dials in with the
address 10.1.2.3/29, and a remote router that is reachable across Frame Relay, as shown in
Figure 5-8:
Figure 5-8. Frame Relay gateway
The following set of parameters configures an MP+ Connection profile for the dial-in client in
Figure 5-8:
Ethernet
Connections
mpp-client
Name=mpp-client
Active=Yes
Encaps=MPP
Encaps options
Recv PW=clientpw
IP options
LAN Adrs=10.1.2.3/29
Following is a comparable RADIUS profile:
mpp-client Password="clientpw", User-Service=Dialout-Framed-User
Framed-Protocol=MPP,
Framed-Address=10.10.1.3,
Framed-Netmask=255.255.255.248
Attribute Value
Ascend-Route-IP (228) Enables/disables IP routing for this connection. (IP is enabled by
default. If this attribute is present, it must be set to Route-IP-Yes
for Frame Relay gateway connections.)
Framed-Address (8) Destination IP address, which lies at the end of a PVC whose first
hop is known by the specified DLCI.
Framed-Netmask (9) A subnet mask for Framed-Address.
10.9.8.7/24
Frame Relay
DLCI 55
10.1.2.3/29