Filter
Top Products
4-86 MAX 6000/3000 Network Configuration Guide
Configuring Individual WAN Connections
Configuring terminal-server connections
Example of terminal-mode configuration
This example shows how to configure the password and make the Rlogin option available to
dial-in users.
1 Open Ethernet > Mod Config > TServ Options.
2 Specify the terminal-server password.
Passwd=tspasswd
3 Set the Telnet parameter to Yes.
4 Configure a multiline login prompt.
Ethernet
Mod Config
TServ Options
Login Prompt=Welcome to Ascend Remote Server\Enter your
name:
Prompt Format=Yes
5 Enable the use of the Rlogin command in terminal mode:
Rlogin=Yes
6 Exit the profile and, at the exit prompt, select the exit and accept option.
Configuring immediate mode
When dial-in calls are directed immediately to a host, the MAX unit establishes a session
between the remote user’s PC and that host via Rlogin, Telnet, or TCP. The following
parameters in Ethernet > Mod Config > TServ Options affect the session the unit establishes:
Example of immediate-mode configuration
To configure immediate Telnet service relying on the Telnet host for authentication:
1 Open Ethernet > Mod Config > TServ Options.
2 Set the Immed Service parameter to Telnet.
3 Specify the name or IP address of the Telnet host.
4 If appropriate, specify the TCP port to use on the Telnet host.
5 Set the Telnet Host Auth parameter to Yes.
Parameter Specifies
Immed Service A particular type of service for establishing an immediate host
connection for dial-in users. You can specify Telnet, Raw-TCP,
Rlogin, or X25-PAD. For details about X.25, see Chapter 6,
“Configuring X.25.”
Immed Host
The hostname or address to which users connect in terminal-server
immediate mode.
Immed Port
A TCP port number to use for the connections.
Telnet Host Auth
Whether the MAX unit bypasses terminal-server authentication and
goes right to a Telnet login prompt.