Filter
Top Products
DEFINITY ECS Release 8.2 ATM Installation,
Upgrades, and Administration
555-233-124
Issue 1
April 2000
Administering ATM-PNC and ATM-CES
5-6Administering DEFINITY ECS
5
11. Set the MAC
address
(Steps 10-13)
Set
Address format
to one of the following:
E.164 ATM private
,
DCC
, or
ICD
NOTE:
If other ATM applications are installed ask the
ATM system administrator to determine which
address format to use. The system default is
DCC.
12. Fill in information
from worksheet
Set
HO DSP:
xxxxxxxx,
fill in information from the
ATM worksheet (
Appendix A, ‘‘Baselining the
Customer’s Configuration’’).
13. Enter the ESI
address
Type in the ESI from the ATM worksheet (
Appendix A,
‘‘Baselining the Customer’s Configuration’’) (MAC
address) of the TN2305/TN2306 in the EPN.
NOTE:
The first 13 bytes auto set after initial entry.
Just enter the MAC address from each
column for each TN2305/TN2306 circuit
pack.
14. Set the Sel field Set the Sel: field to
00
.
NOTE:
Steps 11-13 make up the 20-byte ATM
address.
15. If duplicated
PNC (critical
reliability),
enable PNC
change
system-parameters
duplication
Set
Enable Operation of SPE Duplication?
field to
y
Set
Enable Operation of PNC Duplication?
field to
y
(
Screen 5-4
)
16. Repeat for all
PNs
Repeat Steps 7-13 until all port networks are
administered.
17. Check
administration
list atm pnc
Verify that all ATM connections are administered.
18. Check links
list sys-link
Types EAL (EPN) and PACL (all PNs) should display.
19. Administer the
DEFINITY ECS
synchronization
change
synchronization
Synchronize all signals.
20. Set primary
timing reference
Set
primary
:
atm-sw
.
21. Set secondary
timing reference
Set
secondary
:
atm-sw
. Press Enter to effect the
changes.
22. Save translations save translations Save translations to system disk.
Table 5-4. ATM-PNC administration — Continued
√
Step Action Command Description
Continued on next page