Lucent Technologies Comcode 108678723 Server User Manual


 
DEFINITY ECS Release 8.2 ATM Installation,
Upgrades, and Administration
555-233-124
Issue 1
April 2000
Preparing for Installation and Upgrades
1-4Review Configuration and Equipment
1
Required Hardware
Table 1-1 lists the required equipment for standard, high, critical reliability, and
ATM network duplication configurations.
To test the synchronization splitters, you need the following equipment:
Phoenix 1541C Test Set with accessory cord kit
Phoenix 5575A T1 Test Set with cord kit or equivalent
700A DS1 CPE Loopback Jack
1
(comcode 10798867)
103A block
1541CC cable kit
Table 1-1. Minimum required equipment for Release 8 ATM-PNC configurations
Equipment
Reliability level
Standard High
Critical/ATM
Network Duplication
ATM switch 1 1 2
TN2305/TN2306 ATM interface
1
for each PN
1. TN2305 (multimode fiber); TN2306 (single-mode fiber) for Release 8 ATM-PNC.
11
2
2. High reliability requires 2 ATM-EI circuit packs in the PPN and 1 ATM-EI in each EPN.
2
T1 or E1 synchronization splitter
3
3. The number and uses of the synchronization splitter depend on the configuration and the source(s)
from which primary and secondary synchronization is derived. You may need 1 sync splitter per
ATM switch. DS1 synchronization requires either no sync splitter or up to a number twice the
number of sites.
11 1
SC-connected fiber optic cable
4
4. Existing fiber optic cable may require an ST-to-SC adapter, depending on the interface at the ATM
switch. The
TN2305/TN2306 circuit pack requires an SC connector (1 adapter is included in the
Fiber Pass-Through Kit).
1 2 (PPN)
1 (each EPN)
2
TN771 maintenance/test circuit
pack
5
5. For network duplication; required for systems supporting PRI, BRI, or ASAI.
1
1. See DEFINITY ECS Release 8 Maintenance for R8r, Chapter 6, DS1 Loopback Test for
more information.