Filter
Top Products
DEFINITY ECS Release 8.2 ATM Installation,
Upgrades, and Administration
555-233-124
Issue 1
April 2000
Troubleshooting
6-42Troubleshooting ATM-PNC
6
Screen 6-16. PNC measurements pairs screen (change/display atm pnc-pairs)
Field descriptions
list measurements atm pnc-latency
This command reads and displays the collected information regarding ATM cell
latency and connection times. The command-line syntax is:
■ list measurements atm pnc-latency
[
last-hour, today-peak,
yesterday-peak
] [
print | schedule
]
NOTE:
If a PN pair is changed during a 24-hour period, the peak value reported for
the (new) pair is the highest latency measured after the change. If you type
list measurements atm pnc-latency
and press
Enter while the PNC
duplication feature is disabled, the output contains data for A-PNC only.
Measurements are displayed only for administered pnc-pairs. That is, if 5 pairs
were administered on the ATM PNC Measurements Pairs screen, the
list
measurements atm pnc-latency
output consists of 5 measurement entries. If
the system time has been modified through the
set time
command during any
measurement hour Y, that measurement hour is displayed as Y** instead of Y00,
to indicate that the data for that hour may be invalid.
Pair
Identifies the port network pair number (read only).
Orig PN
Dest PN
These entries identify the originating port network and the
destination port network for the measured SVCs (values
are between 1 and 44; default is
blank
).
change atm pnc-pairs
PNC MEASUREMENTS PAIRS
Pair Orig Dest
PN PN
1 1
5
2 1 8
3 5 8
4 5 7
5 4 2
6 10 11
7 10 12
8 10 1
9 1 10