Filter
Top Products
Using the Flex-Bay
Introducing Your TransPort LT
34
C
AUTION
:
If your Operating System is Windows 98, you can use the SmartBay Utility
to hot-swap the devices. If you do not use Windows 98, make sure that the
computer’s power is off before you remove or install any devices.
To Remove a Device from the Flex-
Bay
1. Turn the computer’s power off.
2. Close the LCD panel, and turn the computer over so that the bottom of the unit
faces up.
3. Pull up on the Flex-Bay latch and pull the device from the bay (Figure 11).
Figure 11. Removing a Device from the Flex-Bay
4. Remove the device out of the bay.
To Install a Device in the Flex-Bay
1. Turn the computer off.
2. Place the device into the bay.
3. Push the device in until it is flush with the chassis.
4. Push down on the Flex-Bay latch until the latch snaps into place.
Your computer’s Operating System automatically recognizes the device in the
Flex-Bay and configures your computer accordingly.
Using the SmartBay Utility
If your computer shipped with Windows 98, you can use the SmartBay utility to
hot-swap your devices in the flex-bay. Currently SmartBay is not functional in
Windows NT and Windows 2000.
Flex-Bay latch