Filter
Top Products
8.5SPECIAL FEATURES
1
2
3
4
5
6
7
8
11
12
13
14
A
SPECIAL FEATURES
Creating or modifying a Macro
1
Press MACRO PROGRAM.
1.Set Macro
/
/Enter
2
Press ENTER.
Select Macro Key
M1:No Command Stored
3
Press the Macro key you want to create or modify.
Then press
ENTER.
4
If you are creating a new macro, skip to next step.
If you are modifying the macro already stored, the following two displays will appear
alternately.
M1:Overwrite?
Yes Enter
M1:Overwrite?
No Cancel
• To overwrite the recording, press ENTER.
• To change only the macro name, press
CANCEL and go to the step 9.
5
The copy standby display appears and the machine begins to beep which indicates the
machine is in the macro programming mode.
Copy Ready 01
Auto Ltr 100%
6
Press the keys exactly as you operate the job you want to program into a macro key.
• The machine beeps during programming to confirm macro programming mode.
• You can program up to 60 steps. When it comes over 60 steps, the machine asks if
you want to register the operations you have entered.
Too Many Steps
Yes Enter
Too Many Steps
No Cancel
If you want to register them, press ENTER.
If you want to abort, press
CANCEL.
•
When you press
ENTER or START at the end of operation you are programming, the
machine shows:
Include Start/Enter?
Yes Enter
Include Start/Enter?
No Cancel
If you want the machine to start the programmed operation immediately by press-
ing the macro key, press
ENTER.
If you want the machine to prompt you press
START or ENTER before starting the
recorded operation, press
CANCEL. Then go to the step 8.
7
Press MACRO PROGRAM.
M1:Name ;Upper
_
The machine prompts you to enter the name of macro.
If you do not want to enter or change it, skip to the step 9.