Filter
Top Products
CX2032 MFP User’s Guide Installing upgrades
136
Adjusting windows printer drivers
Once your new upgrade has been installed, you may need to update the
Windows printer driver so that the additional features are available to
your Windows applications.
Remember that if your MFP is shared between users on different
computers, the driver must be adjusted on each user’s machine.
The illustrations shown here are for Windows XP. Other Windows
versions may appear slightly different, but the principles are the same.
PCL driver
If you have installed a memory upgrade it is not necessary to change the
PCL printer driver, and you can ignore this section.
If you have installed a duplex unit or hard disk, proceed as follows:
PCL DevOption (288).bmp
1. Open the Printers window (called
“Printers and Faxes” in Windows XP) via
the Start Menu or from the Windows
Control Panel.
2. Right-click the printer icon for this
printer, and choose Properties from the
pop-up menu.
3. On the Device Options tab, check the
box for the upgrade you have just
installed.
4. Click OK to close the properties window, and then close the
Printers window.
Postscript driver
This driver must be adjusted for any upgrade just installed.
PS DevSettings Tab.eps
1. Open the Printers window (called
“Printers and Faxes” in Windows XP)
via the Start Menu or from the
Windows Control Panel.
2. Right-click the printer icon for this
printer, and choose Properties from
the pop-up menu.
3. On the Device Settings tab, locate the
list of installable options. Change