Filter
Top Products
Maintenance/replacement
106 - ENGLISH
Maintenance
13) Press the power button on the control panel or on the remote control to start
video projection.
14) Press the <MENU> button to display the menu screen and then press
to select
[PROJECTOR SETUP].
15) Press the <ENTER> button and then press
to select [LAMP RUNTIME].
16) Hold the <ENTER> button for approximately three seconds.
z
The [LAMP RUNTIME] conrmation message is displayed.
LAMP RUNTIME
LAMP RUNTIME RESET.
OK CANCEL
17) Press
to select [OK], and press the <ENTER> button.
z
The lamp usage time (converted value) is reset to 0 and the power is turned off. After a short while, the
projector enters the standby mode.
Attaching the top cover
Hold the top cover as shown in the following gure, align the hinge with the support,
and while pushing the arm in the direction of the arrow (towards the inner side of the
projector), push it into the groove.
Arm
Support
Hinge
Groove