Filter
Top Products
[NETWORK] menu
84 - ENGLISH
Settings
Error information page
When [Error (Detail)] is displayed on the [Projector status] screen, click it to display the error details.
z
The projector may go into the standby status to protect the projector depending on the contents of the
error.
[OK]: Normal operation
[FAILED]: Occurrence of trouble
[WARNING]: Warning
z
Description of problem occurrence [FAILED]:
Item Description
[MAIN CPU BUS]
There is a problem with the microcomputer circuitry. Consult your
dealer.
[FAN]
There is a problem with the fan or the fan drive circuit. Consult your
dealer.
[INTAKE AIR TEMPERATURE]
The intake air temperature is too high. It may be used in an operating
environment where the temperature is high, such as near a heating
appliance, the intake port may be blocked, or the air lter may be
clogged.
[EXHAUST AIR TEMPERATURE]
The exhaust air temperature is too high. The air exhaust port may be
blocked, or the mode setting for using the projector at high elevations
may be wrong.
[LAMP REMAIN TIME]
The lamp usage time has exceeded the specied time, and it is time
to replace the lamp.
[LAMP STATUS]
The lamp has failed to turn on. Wait a while until the luminous lamp
cools off, and then turn on the power.
[APERTURE(CONTRAST-SHUTTER)]
There is a problem with the contrast shutter circuitry. Consult your
dealer.
[INTAKE AIR TEMP.SENSOR]
There is a problem with the sensor used to detect intake air
temperature. Consult your dealer.
[EXHAUST AIR TEMP.SENSOR]
There is a problem with the sensor used to detect exhaust air
temperature. Consult your dealer.
[BATTERY] The battery replacement is required. Consult your dealer.
[AIR FILTER]
There is too much dust accumulated in the air lter unit.
Turn the <MAIN POWER> switch to <OFF> (
page 38), and clean
the air lter (
page 99).