Filter
Top Products
[PICTURE] menu
52 - ENGLISH
Settings
4) Adjust [FULL SCAN(B)]/[SINGLE LINE
SCAN(B)].
z
Select the [PICTURE] menu
→
[ADVANCED
MENU] and press
to adjust [BRIGHTNESS
B] and then [CONTRAST B].
[BRIGHTNESS B]
Adjusts the black level of the
display signal to 0% (0 IRE or
7.5 IRE).
z
Setting range
-
16 to +16
[CONTRAST B]
Adjusts the white level of the
display signal to 100% (100 IRE).
z
Setting range
-
32 to +32
To set [MONITOR POSITION]
You can set the display position of the input waveform
during the full scan display.
Press
to switch [MONITOR POSITION].
z
The setting will change as follows each time you
press the button.
[UPPER LEFT]
[UPPER CENTER]
[UPPER RIGHT]
[LOWER RIGHT]
[LOWER CENTER]
[LOWER LEFT]
[UPPER LEFT]
Displays the input waveform on
the upper left.
[UPPER
CENTER]
Displays the input waveform on
the upper center.
[UPPER RIGHT]
Displays the input waveform on
the upper right.
[LOWER LEFT]
Displays the input waveform on
the lower left.
[LOWER
CENTER]
Displays the input waveform on
the lower center.
[LOWER
RIGHT]
Displays the input waveform on
the lower right.
To set [AUTO ADJUST]
The luminance level of the output signal from a
connected external device is automatically adjusted
by setting the automatic waveform adjustment items.
1) Press
to select an adjustment
item.
Automatic waveform adjustment
items
Factory
default
[START AUTO ADJUST] —
[BLACK LEVEL ADJUST] [ON]
[WHITE LEVEL ADJUST] [ON]
[RGB ADJUST (BLACK)] [OFF]
[RGB ADJUST (WHITE)] [OFF]
2) Press
to switch the adjustment.
3) Press
to select [START AUTO
ADJUST], and press the <ENTER>
button.
z
The [PROCESSING] message is displayed.
When adjustment is complete, a conrmation
message for applying results is displayed.
4) Press
to select [OK].
5) Press the <ENTER> button.
Note
z
When [BLACK LEVEL ADJUST] is [ON], the
display signal Y (brightness) value’s black level is
automatically adjusted to the 0% position.
z
When [WHITE LEVEL ADJUST] is [ON], the
display signal Y (brightness) value’s white level is
automatically adjusted to the 100% position.
z
When [RGB ADJUST (BLACK)] is [ON], the display
signal R (Red), G (Green), and B (Blue) value’s
black level are all automatically adjusted to the 0%
position.
z
When [RGB ADJUST (WHITE)] is [ON], the display
signal R (Red), G (Green), and B (Blue) value’s
white level are all automatically adjusted to the
100% position.
z
If [WAVEFORM MONITOR] is [OFF], [AUTO
ADJUST] cannot be executed.
z
Project the luminance adjustment signal of a
commercial test disk etc., and perform automatic
adjustment. However, even with an adjustment
disk, correct adjustment may not be possible if
noise is included on the disk itself or the playback
device generates noise.