Filter
Top Products
[PROJECTOR SETUP] menu
ENGLISH - 67
Settings
[INITIAL START UP]
Set the mode for start-up when the <MAIN POWER>
switch is turned <ON>.
1) Press
to select [INITIAL START UP].
2) Press
to switch [INITIAL START UP].
z
The setting will change as follows each time
you press the button.
[LAST MEMORY]
[STANDBY] [ON]
[LAST
MEMORY]
Starts up the projector in the
mode it was in before the <MAIN
POWER> switch is turned to
<OFF>.
[STANDBY] Starts up in the standby mode.
[ON] Starts projection immediately.
[PROJECTION METHOD]
You can set the projection method in accordance with
the installation status of the projector.
Change the projection method if the screen display is
upside down or inverted.
1) Press
to select [PROJECTION
METHOD].
2) Press
to switch [PROJECTION
METHOD].
z
The setting will change as follows each time
you press the button.
[FRONT/DESK] [FRONT/CEILING]
[REAR/CEILING] [REAR/DESK]
[FRONT/DESK]
When installing on the desk, etc.,
in front of the screen
[FRONT/
CEILING]
When installing using the ceiling
mount bracket (optional) in front of
the screen
[REAR/DESK]
When installing on the desk,
etc., behind the screen (using a
translucent screen)
[REAR/CEILING]
When installing using the ceiling
mount bracket (optional) behind
the screen (using a translucent
screen)
[HIGH ALTITUDE MODE]
If you use the projector at high elevations (1 400 m
(4 593 ft) or higher and lower than 2 700 m (8 858 ft)),
[ON] must be set.
1) Press
to select [HIGH ALTITUDE
MODE].
2) Press
to switch [HIGH ALTITUDE
MODE].
z
The setting will change as follows each time
you press the button.
[OFF] [ON]
[OFF]
When using at a place lower than
1 400 m (4 593 ft) above sea level
[ON]
When using at elevations (1 400 m
(4 593 ft) or higher and lower than
2 700 m (8 858 ft) above sea level)
Note
z
Make sure to set this to [OFF] when you use the
projector at elevations lower than 1 400 m (4 593 ft)
above sea level, and set this to [ON] when you use
the projector at elevations of 1 400 m (4 593 ft) or
higher and lower than 2 700 m (8 858 ft). Failure to
do so may shorten the life of the internal parts and
result in malfunctions.
z
Do not install the projector at elevations of 2 700 m
(8 858 ft) or higher above sea level. Failure to do so
may shorten the life of the internal parts and result
in malfunctions.
z
The speed of the fan is raised and the operation
sound will become louder when this is set to [ON].