Filter
Top Products
Precautions for use
ENGLISH - 15
Important
Information
Do not tilt the projector or place it on its side.
Do not tilt the projector body more than approximately ±30° vertically or ±10° horizontally. Overtilting may
result in shortening the life of the components.
30°
30°
Do not cover the air intake/exhaust ports or place anything within 100 mm (4")
of them.
Avoid using the projector at places where there are higher static electricity
levels as far as possible.
z
When using the projector in places such as on a carpet where there are static electricity, communication
using wired LAN may be distorted.
In such cases, remove the source of static electricity or noise and connect wired LAN again.
z
In rare cases, communication via LAN may not be possible due to static electricity or noise.
In such cases, press the power
button on the remote control or control panel to turn off the power of
the projector.
After the cooling fan is stopped (after the power indicator <ON (G)/STANDBY (R)> of the projector body
that is illuminating orange changes the indication to illuminate or ash red), turn on the power and connect
to the LAN again.
Cautions when setting the projectors
z
Do not stack the projectors.
z
Avoid heating and cooling air from the air conditioning system directly blow to the ventilation ports (intake
and exhaust) of the projector.
z
Do not block the ventilation ports (intake and exhaust) of the projector.
100 mm (4") or more 100 mm (4") or more 100 mm (4") or more
Air exhaust port
Air intake port
Air intake port