Filter
Top Products
Switching on/off
ENGLISH - 37
Basic Operation
Switching on the projector
Check external device connections before switching
on the projector.
1) Connect the power cord to the
projector.
2) Connect the power plug to an outlet.
3) Press the <ON> side of the <MAIN
POWER> switch to turn on the power.
z
The power indicator <ON (G)/STANDBY (R)>
illuminates or ashes red.
4) Remove the lens cover.
z
Be sure to remove the lens cover before
starting projection.
5) Press the power button.
z
The power indicator <ON (G)/STANDBY (R)>
ashes green, and after a while, changes to
illuminate, and then projection starts.
Attention
z
Using the projector while the lens cover is attached
causes the device to heat up and can result in a
re.
Note
z
Conrm that [CONTROL PANEL] (when operating
on the control panel) or [REMOTE CONTROLLER]
(when operating with the remote control) is set
to [ENABLE] from the [SECURITY] menu
→
[CONTROL DEVICE SETUP] (
page 77).
When you set the [SECURITY] menu, entering a
password is required. (
page 75)
z
When switching on the projector, a small rattling
sound may be heard or when the luminous lamp is
lit, a tinkling sound may be heard, but this is not a
malfunction.
z
During video projection, the cooling fan operates
and makes a sound. This fan sound may change
with ambient temperature and becomes louder
when the lamp is turned on.
z
Setting the [PROJECTOR SETUP] menu
→
[LAMP
POWER] (
page 68) to [ECO] reduces operation
sounds.
z
When the lamp is turned off and immediately
turned back on again, the video may temporarily
icker slightly at the start of projection due to lamp
characteristics, but his is not a malfunction.
z
When [ECO] is selected in [STANDBY MODE]
under the [PROJECTOR SETUP] menu
→
[ECO
MANAGEMENT] (
page 69), the initial image may
appear about ten seconds later than when set to
[NORMAL].
z
If the direct power off function was used to set
the <MAIN POWER> switch to <OFF> during
projection, the next time the <MAIN POWER>
switch is set to <ON> with the power plug
connected to an outlet, the power indicator <ON (G)/
STANDBY (R)> will soon illuminate green and an
image will be projected. (When the [PROJECTOR
SETUP] menu
→
[INITIAL START UP] (
page 67)
is set to [LAST MEMORY] or [ON].)
3RZHULQGLFDWRU21*67$1'%<5!