Filter
Top Products
[PICTURE] menu
54 - ENGLISH
Settings
[DAYLIGHT VIEW]
You can correct the image to the optimal vividness
even if it is projected under a bright light.
1) Press
to select [DAYLIGHT VIEW].
2) Press
or press the <ENTER>
button.
z
The [DAYLIGHT VIEW] individual adjustment
screen is displayed.
3) Press
to switch [DAYLIGHT VIEW].
z
The setting will change as follows each time
you press the button.
[AUTO] [ON] [OFF]
[AUTO]
Enables auto correction of
[DAYLIGHT VIEW]. The color
sensor detects the brightness
and color of the surroundings and
automatically corrects the video
display.
[ON] Enables [DAYLIGHT VIEW].
[OFF] Disables [DAYLIGHT VIEW].
Note
z
You cannot set [AUTO] if [REAR/DESK] or [REAR/
CEILING] is selected for [PROJECTION METHOD]
of [PROJECTOR SETUP].
z
The [AUTO] mode may not function properly if an
object is placed on the top of the projector.
[DIGITAL CINEMA REALITY]
You can improve the vertical resolution of 2-2 and 2-3
pulldown video.
This function is available only with the following signal
inputs.
525i (480i), 625i (576i), 1125 (1080)/60i, 1125
(1080)/50i, S-video signal,video signal
1) Press
to select [DIGITAL CINEMA
REALITY].
2) Press
or press the <ENTER>
button.
z
The [DIGITAL CINEMA REALITY] individual
adjustment screen is displayed.
3) Press
to switch [DIGITAL CINEMA
REALITY].
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON]
Enables [DIGITAL CINEMA
REALITY].
[OFF]
Disables [DIGITAL CINEMA
REALITY].
[NOISE REDUCTION]
You can reduce noises when the input image is
degraded and noise is occurring in the image signal.
1) Press
to select [NOISE
REDUCTION].
2) Press
or press the <ENTER>
button.
z
The [NOISE REDUCTION] individual
adjustment screen is displayed.
3) Press
to adjust the level.
Operation Adjustment Range
Press
.
Strengthen the
noise reduction.
Maximum
value +3
Press
.
Weakens the noise
reduction.
Minimum
value 0
Attention
z
When this is set for an input signal with less noise,
the image may look different from what it originally
was. In such case, set the value to 0.