Filter
Top Products
[NETWORK] menu
ENGLISH - 89
Settings
[E-mail set up] page
An E-mail message can be sent to the E-mail address setup in advance (up to two addresses) when the
problem occurred or the lamp usage time reached the specied value.
Click [Detailed set up]
→
[E-mail set up].
(1)
(2)
(3)
(4)
(5)
(6)
(1) [ENABLE]
Select [ENABLE] when using the E-mail function.
(2) [SMTP SERVER NAME]
Enter the IP address or the server name of the E-mail
server (SMTP). To enter the server name, the setup of the
DNS server is required.
(3) [MAIL FROM]
Enter the E-mail address of the projector. (Up to 63
characters in single byte)
(4) [MEMO]
You can enter information such as the location of the
projector that noties the sender of the E-mail. (Up to 63
characters in single byte)
(5) [MINIMUM TIME]
Change the minimum intervals for the temperature warning
mail. The default value is 60 minutes. In this case, another
E-mail will not be sent for 60 minutes after sending the
temperature warning mail even if it reaches the warning
temperature.
(6) [INTAKE AIR TEMPERATURE]
Change the temperature setting for the temperature
warning mail. A temperature warning mail is sent when the
temperature exceeds this value.
(2)
(1)
(1) [E-MAIL ADDRESS 1]
Enter the E-mail address to be sent.
(2) Settings of the conditions to send E-mail
Select the conditions to send E-mail.
[MAIL CONTENTS]:
Select either [NORMAL] or [SIMPLE].
[ERROR]:
An E-mail message is sent when an error occurred in
the self-diagnosis.
[LAMP RUNTIME]:
An E-mail message is sent when the remaining lamp
usage time has reached the value set at the right eld.
[INTAKE AIR TEMPERATURE]:
An E-mail message is sent when the intake air
temperature has reached the value set at the above
eld.
[PERIODIC REPORT]:
Place a check mark on this when E-mail is to be sent
periodically.
It will be sent on the days and time with the check mark.