Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
SWITCHING ON THE MP.11/a
The MP.11/a can be powered by a power supply or by Active Ethernet through an Active Ethernet
splitter. Depending upon the powering method, you can switch the MP.11/a on by:
▪ Plugging the power cord of the power supply into an AC power outlet
▪ Connecting the Active Ethernet splitter to the Ethernet cabling
When the power is switched on, the MP.11/a performs startup diagnostics. When startup is completed,
the LEDs show the operational state of the MP.11/a (see the following figure).
Powe
r
Ethernet Link
Wireless Link
The following table shows the status of the four LEDs when the MP.11/a is operational (the
fourth LED is unused).
Power
OFF Power is not present or is malfunctioning.
GREEN Power is present; the unit is operational.
AMBER
The unit is initializing after reboot (less than two minutes); it cannot get a dynamic IP
address or is in Forced Reload state when Ethernet LED also is amber.*
RED A fatal error in the unit.
Ethernet Link
OFF Not connected.
GREEN Connected at 10 Mbps.
BLINKING GREEN Data is being sent.
AMBER
Connected at 100 Mbps, in Forced Reload state when Power LED also is amber*, or
the unit is initializing after reboot (less than two minutes).
BLINKING AMBER Data is being sent.
RED An error in data transfer.
Wireless Link
OFF Wireless interface is up properly but no wireless link established.
GREEN Immediately after connecting a wireless link.
BLINKING GREEN
Data is being sent or the wireless interface is initializing after reboot (less
than two minutes).
RED There is a fatal error on the wireless interface.
* See “Forced Reload” on page 106.
Chapter 2. Installation 15
CPN 65755 Issue Date: August 2003