Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
SYSTEM CONFIGURATION
The System Configuration page lets you change the MP.11/a’s system name, location name, and so on
(see the following System Configuration window). These details help you to distinguish this MP.11/a
from other routers, and lets you know whom to contact in case of problems.
To go to this page, click the Configure button and the System tab.
These settings do not influence the operation of the MP.11/a, with the exception of Mode of Operation,
which sets the MPl.11/a as Bridge (layer 2) or Router (layer 3).
You can enter the following details:
System Name
This is the system name for easy identification of the MP.11/a. Use the system name of this Base
Station to configure the Base Station System Name parameter on a satellite if you want the
satellite to register only with this Base Station. If the Base Station System Name is left blank on
the satellite, it can register with any Base Station that has a matching Network Name and Network
Secret.
Country (Tsunami MP.11a units only)
This field is available on Tsunami MP.11a units only; when you choose a country with a regulatory
domain that requires Dynamic Frequency Selection (DFS) or Transmit Power Control (TPC), they
are enabled automatically. The Country selection pre-selects and displays only the allowed
frequencies for that country. Click the Configure button, the Interfaces tab, and the Wireless sub-
tab to see the channel/frequency list.
Chapter 4. Basic Management 31
CPN 65755 Issue Date: August 2003