Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
Warning!
When the remote interface accidentally is set at too small a value and communication is lost, it
cannot be reconfigured remotely and a local action is required to bring the communication back.
Therefore, the best place to experiment with the level is at the unit that can be managed without
going through the link; if the link is lost, the setting can be adjusted to the correct level to bring
the link back.
To set the Satellite Density, click the Configure button, then the Interfaces tab and the Wireless sub-
tab. Make your density selection from the drop-down menu. This setting requires a reboot of the unit.
Sensitivity threshold settings related to the density settings are:
Satellite Density
Large Medium Small Mini Micro
Receive Sensitivity Threshold
-99 dBm -90 dBm -85 dBm -72 dBm -66 dBm
Defer Threshold
-95 dBm -85 dBm -75 dBm -62 dBm -56 dBm
MONITOR
Use this section of the interface to obtain detailed information about the settings and performance of the
MP.11/a. There are 10 tabs in the Monitor section.
1) Wireless
General
Click the Monitor button and the General tab to monitor the general performance of the wireless
interface.
Chapter 5. Web Interface 69
CPN 65755 Issue Date: August 2003