Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
Ceiling Mounting
Follow these steps to mount the MP.11/a to a ceiling.
1. Unplug the MP.11/a’s power supply, if necessary.
2. Use a Phillips screwdriver to attach the metal base to the underside of the MP.11/a, if you have not
already done so. See “Installation Procedure” on page 11 for an illustration.
3. Feed a mounting screw through each of the four rubber feet. The MP.11/a comes with four 3.5 mm
x 40 mm pan-head screws.
4. Remove the screws from the rubber feet.
5. Turn the MP.11/a upside down and position the base against the ceiling where you want to mount
the unit.
6. Mark the center of the four mounting holes in the rubber feet.
7. Set the MP.11/a aside and drill a hole at each of the locations you marked above. Each hole should
be wide enough to hold a mounting plug (6 mm x 35 mm).
8. Insert a plug into each hole. The MP.11/a comes with four 6 mm x 35 mm plugs.
9. Insert the screws into the holes you made previously in the rubber feet.
10. Insert the screws into the mounting plugs. Use a screwdriver to tighten the screws and attach the
MP.11/a’s metal base to the ceiling.
Chapter 2. Installation 18
CPN 65755 Issue Date: August 2003