Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
Quit Command
The quit, done, and exit commands are used to disconnect and close the current CLI session.
Reboot Command
Use the reboot command to signal the MP.11/a to reboot after a specified number of seconds.
reboot <number of seconds>
The <number of seconds> parameter must be positive. Specify a value of 0 (zero) for an immediate
reboot.
Save Command
Use the save command to save the current configuration of the MP.11/a to flash memory.
save config
Search Command
Use the search command to list the parameters supported by the specified table. This list corresponds
to the table information displayed in the HTTP interface.
search <table name>
See “Table Parameters” on page 97 for details.
Set Command
The set command lets you change parameter values. You can set a single parameter value, or you
can set a group of parameters or a table with parameters. If a parameter requires more than one value,
the values must be separated by spaces.
For example, to set the MP.11/a IP address parameter:
set ipaddrtype static
set ipaddr 1 ipaddress 10.0.0.12
Some parameter values change only when the MP.11/a is rebooted. In these cases, the CLI warns you
that a reboot is required for the change to take effect.
See “Show and Set Parameters” on page 88 for a list of parameters that can be used with the set
command.
Chapter 6. Command Line Interface 85
CPN 65755 Issue Date: August 2003