Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
SNMP PARAMETERS
Set Read and Read/Write Passwords
snmp R
SNMP Group
snmpipsccesstbl RW
SNMP IP Access Table
index R
Index
ipaddr RW
IP address
submask RW
Subnet mask
if RW
Interface [1=Ethernet, 2=PC Card A, 3=PC Card B]
cmt RW
Comment
status RW
Status of table entry [1=enable, 2=disable, 3=delete]
snmptraphosttbl RW
SNMP Trap Host Table
index R
Index
ipaddr RW
IP address
passwd W
Password
cmt RW
Comment
status RW
Status of table entry [1=enable, 2=disable, 3=delete]
snmprpasswd W
Read password
snmprwpasswd W
Read/write password
Example: This command adds and enables a new entry to the SNMP IP Access Table with IP
address 10.0.0.2, subnet mask 255.255.255.0 on an Ethernet interface.
set snmpipaccesstbl 0 ipaddr 10.0.0.2 submask 255.255.255.0 if 1 status 1
SECURITY PARAMETERS
MP.11/a Security Settings
security R
Security Configuration Group
secconfig RW
Security configuration
secenckeylentbl RW
Encryption Key Length Table
index R
Index
enckeylen RW
Encryption Key Length
SPANNING TREE PARAMETERS (Bridge mode only)
Help prevent network loops
stp R
Spanning Tree Group
stptbl RW
Spanning Tree Table
index R
Index
priority RW
Bridge priority
pathcost RW
Path cost
status RW
Status of table entry [1=enable, 2=disable]
stpstatus RW
Spanning Tree status [1=enable, 2=disable]
stppriority RW
Bridge priority
stpmaxage RW
Maximum age
stpbridgehellotime W
Hello time
stpfwddelay RW
Forward delay
Chapter 6. Command Line Interface 92
CPN 65755 Issue Date: August 2003