Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
Wall Mounting
Follow these steps to mount the MP.11/a on a wall.
1. Identify the location where you intend to mount the unit.
2. Unplug the MP.11/a’s power supply, if necessary.
3. Use a Phillips screwdriver to remove the metal base from the underside of the MP.11/a, if
necessary.
4. Press down on the cable cover lock to release the cable cover (see “Installation Procedure” on page
11 for illustrations for this and the next 3 steps).
5. Remove the cable cover from the unit.
6. Remove the front cover from the unit.
7. Remove the back cover from the unit.
8. Place the back cover on the mounting location and mark the center of the three mounting holes.
9. Remove the cover from the wall and drill a hole at each of the locations you marked above. Each
hole should be wide enough to hold a mounting plug (which is 6 mm x 35 mm).
10. Insert a plug into each hole. The MP.11/a comes with four 6 mm x 35 mm plugs; you only need to
use three of these when wall-mounting the unit.
11. Insert a screw into each of the mounting holes molded into the back cover. The MP.11/a comes
with four 3.5 mm x 40 mm pan-head screws; you only need to use three of these when wall-
mounting the unit.
12. Insert the screws into the wall plugs. Use a screwdriver to tighten the screws and attach the back
cover to the wall.
13. Attach Ethernet and power cables to the MP.11/a unit, as necessary.
14. Snap the unit into the back cover, replace the front cover, and replace the cable cover.
15. Turn on the MP.11/a (see “Switching On the MP.11/a” on page 15).
Chapter 2. Installation 17
CPN 65755 Issue Date: August 2003