Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
Transmit Power Control
Transmit Power is a manual configuration selection to reduce the output power in the radio. The output
power level for the operating frequency can be found in the Event Log of the MP.11a embedded
software.
For more information about Transmit Power Control, see “Interface Configuration: Wireless Slot” on
page 34.
COMMAND LINE INTERFACE OVERVIEW
The Command Line Interface (CLI) is a text-based interface with which you can configure and manage
the MP.11/a by entering commands. This section describes only how to access the CLI; the interface
itself is described in “Chapter 6. Command Line Interface” on page 79.
The CLI can be used as an alternative to the Web Interface. You can, for example, quickly change the
settings of the MP.11/a by running commands in a batch.
The CLI is accessible through the:
▪ Ethernet port connected through the network or with a cross-over Ethernet cable between the
computer and the MP.11/a
▪ Serial port of the MP.11/a
Ethernet Port
To use the CLI through the Ethernet port, you must have a telnet program and the IP address of the
MP.11/a. On most computers, the telnet program is called telnet. See “MP.11/a IP Address” on page
19 for details.
To access the MP.11/a through Ethernet:
1. From the Windows Start menu, select Run; enter
cmd and click OK.
2. Enter telnet followed by the IP address, as shown in the following sample DOS command
window.
3. You are prompted for your password:
Please enter password:
4. Enter the password (the default password is public).
You can now use the CLI.
Chapter 3. Management Overview 24
CPN 65755 Issue Date: August 2003