Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
Ethernet Port
To configure the Ethernet interface, click the Configure button, the Interfaces tab, and the Ethernet
sub-tab.
You can set the following parameter from this tab.
Configuration
Select from the following settings for the type of Ethernet transmission (Configuration drop-down
box):
10 Mbit/s – half-duplex
10 Mbit/s – full-duplex
10 Mbit/s – auto-duplex
100 Mbit/s – half-duplex
100 Mbit/s – full-duplex
autospeed-half-duplex
autospeed-auto-duplex
Half-duplex means that only one side can transmit at a time.
Full-duplex allows both sides to transmit.
Auto-duplex selects the best transmission mode for the given configuration.
The recommended setting is auto-speed-auto-duplex.
MONITORING SETTINGS
The MP.11/a offers various facilities to monitor its operation and interfaces. Only the most significant
monitoring categories are mentioned here.
Chapter 4. Basic Management 38
CPN 65755 Issue Date: August 2003