Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
History Command
Use the history command to show this list of commands. Commands entered in the current session
are stored in a Command History Buffer. To avoid re-entering long command statements, use the
keyboard up arrow (↑) and down arrow ( ↓) keys to recall previous statements from the Command
History Buffer. When the desired statement reappears, press the Enter key to execute, or you can edit
the statement before executing it.
history
Log Command
Use the log command to manage the event log file maintained by the MP.11/a.
To append a user-specified string to the event log, enter:
log addstring <anyString>
To append a user-specified string multiple times to the event log, enter:
log addmany <numMsgs> <anyString>
To reset the event log, enter the following. Note that this generates an event log message stating that
the log has been reset intentionally.
log reset
To display the contents of the entire event log, enter:
log dump
To display the current number of log entries:
log count
To display the log entry corresponding to the specified number, enter:
log display <msgNum>
The first log entry is numbered 0. If no parameter is supplied, the entire event log is displayed.
Passwd Command
Use the passwd command to change the password used to access the CLI.
passwd <old password> <new password> <new password>
Enter the new password twice to ensure no mistake was made when specifying the new password. If
you forget the CLI password, there is no way to retrieve it from the MP.11/a and the CLI cannot be
accessed. In this case, the MP.11/a must be reset to factory defaults. The default password for the CLI
is public.
Chapter 6. Command Line Interface 84
CPN 65755 Issue Date: August 2003