Filter
Top Products
Tsunami MP.11and MP.11a Installation and Management
You can set the Configuration parameter: Select from these settings for the type of Ethernet
transmission (Configuration drop-down box):
10 Mbit/s – half-duplex 100 Mbit/s – full-duplex
10 Mbit/s – full-duplex autospeed – half-duplex
10 Mbit/s – auto-duplex autospeed – auto-duplex
100 Mbit/s – half-duplex
Half-duplex means that only one side can transmit at a time.
Full-duplex allows both sides to transmit.
Auto-duplex selects the best transmission mode for the given configuration.
4) SNMP
Click the Configure button and the SNMP tab to set passwords, set trap host IP addresses, and limit
access to the MP.11/a management interface. You can enable: All Interfaces, Only Ethernet, Only
Slot A, or None.
Trap Groups
You can enable or disable different types of traps in the system. By default, all traps are enabled.
Trap Host Table
This table shows the SNMP management stations to which the MP.11/a sends system traps.
Chapter 5. Web Interface 54
CPN 65755 Issue Date: August 2003