Filter
Top Products
A – Command Line Interface
Image Command
A-38 59022-11 A
0
9. Open an Admin session to acquire the necessary authority.
SANbox2 $>admin start
10. Display the list of firmware image files on the switch to confirm that the file
was loaded.
SANbox2 (admin) $>image list
11. Unpack the firmware image file to install the new firmware in flash memory.
SANbox2 (admin) $>image unpack filename
12. Wait for the unpack to complete.
image unpack command result: Passed
13. A message will prompt you to reset the switch to activate the firmware.
Resetting the switch is disruptive. Use the Hotreset command to attempt a
non-disruptive activation.
SANbox2 (admin) $>hotreset
Examples The following is an example of the Image Install command:
SANbox2 (admin) #> image install
Warning: Installing new firmware requires a switch reset.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
User Account : johndoe
IP Address : 10.20.33.130
Source Filename : 5.0.00.11_x86
About to install image. Do you want to continue? [y/n] y
Connected to 10.20.33.130 (10.20.33.130).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.