Filter
Top Products
A – Command Line Interface
Reset Command
59022-11 A A-45
0
services
Resets the switch services configuration to the default values as described in
Table A-15.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table A-13 for SNMP configuration default values.
switch
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
Activates the pending firmware.
Closes all management sessions.
Clears the event log. To save the event log before resetting, refer to the ”Set
Log Command” on page A-71.
To reset the switch with a power-on self test, refer to the ”Hardreset Command” on
page A-32. To reset the switch without disrupting traffic, refer to the ”Hotreset
Command” on page A-35.
system
Resets the system configuration settings to the factory default values. as
described in Table A-16.
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration values (autosave, default visibility) remain unchanged.
Note: Because this keyword changes network parameters, the
workstation could lose communication with the switch.