Filter
Top Products
A – Command Line Interface
Reset Command
A-44 59022-11 A
0
Reset Command
Resets the switch configuration parameters. If you omit the keyword, the default is
Reset Switch.
Authority Admin session
Syntax reset
config [config_name]
factory
port [port_number]
radius
security
services
snmp
switch (default)
system
zoning
Keywords config [config_name]
Resets the configuration given by [config_name] to the factory default values for
switch, port, port threshold alarm, and zoning configuration as described in
Table A-9 through Table A-12. If [config_name] does not exist on the switch, a
configuration with that name will be created. If you omit [config_name], the active
configuration is reset. You must activate the configuration for the changes to take
effect. for switch, port, and port threshold alarm configuration default values.
factory
Resets switch configuration, port configuration, port threshold alarm configuration,
zoning configuration, SNMP configuration, system configuration, security
configuration, RADIUS configuration, switch services configuration, and zoning to
the factory default values as described in Table A-9 through Tabl e A-17. The
switch configuration is activated automatically.
port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning
with 0.
radius
Resets the RADIUS configuration to the default values as described in
Table A-14.
security
Clears the security database and deactivates the active security set. The security
configuration value, autosave, and fabric binding remain unchanged.
Note: Because this keyword changes network parameters, the
workstation could lose communication with the switch and
release the Admin session.