Filter
Top Products
Error Messages and Their Meanings
65
5
Error Messages and Their Meanings
If there is an error, one of the following messages may appear on the display. If
other message appears, follow the message.
Message Causes and solutions
Put original back, check it and
press Start key.
Original jammed during Memory Transmis-
sion. Place originals that have not been
scanned again.
Error occurred, and trans. was
cancelled.
A document jam occurred during Immediate
Transmission. Press the
{
{{
{OK}
}}
}
key, and then re-
send the pages that have not been sent.
An error occurred during Immediate Trans-
mission. Press the
{
{{
{OK}
}}
}
key, and then resend
the original.
Note
❒
There may be a problem with the machine
or the telephone line (for example noise or
cross talk). If the error reoccurs frequently,
contact your service representative.
Cannot detect original size.
Place original again, then
press
Start key.
The machine failed to detect the size of the
original. Place originals again, and then press
the
{
{{
{Start}
}}
}
key.
Memory is full. Scanning will
be stopped and only scanned
page(s)
will be stored.
If you press
[Exit]
, the machine returns to
standby mode and starts transmitting the pag-
es that have been stored.
Cannot send fax as scanner is in
use by another function.
The Copy function is in use. To cancel the job
in process, do the following, and then try fax-
ing again.
Press
[Exit]
, and then press the
{
{{
{Copy}
}}
}
key.
Next press the
{
{{
{Clear/Stop}
}}
}
key. When the mes-
sage “
[Stop] key was pressed.
Stop copying?
” appears, press
[Stop]
.
Updating the settings. Re-se-
lect dest./functions after up-
date finishes.
Wait with the main power switch on. The ma-
chine will enter standby mode after it exits
from RDS mode.
Kir-C2-AEcombine_F_FM.book Page 65 Monday, September 29, 2003 11:36 AM