Filter
Top Products
4-16
Section 4— Switcher Operations
Learning User Wipes
If you develop a wipe setup that you like and you want to save it
temporarily, you can do so using the User 1– 6 buttons on the Wipe
Subpanel.
1. Press LEARN USER WIPE, followed by one of the six User
buttons, such as USER 1. The current wipe setup, including
Border, Edge, and Aspect settings, will be stored in the User
button you selected.
2. To recall a stored user wipe, simply press the appropriate User
button. The wipe system will immediately recall the wipe
setup previously stored in that User register. (Recalls one
pattern at a time.)
NOTE:
If you press a User Wipe button that hasn’t been learned, that
button won’t light. In that case, the current wipe settings remain in
effect.
3. If you learn a wipe into a User Wipe button, or do a User Wipe
recall by mistake, you can undo the learn or recall by pressing
USER WIPE UNDO immediately following the learn or recall.
NOTE:
User Wipes are a temporary “scratch pad” and are not stored in
E-MEM.