Filter
Top Products
2-2
Section 2— Startup and Configuration
Booting-Up
When the system is turned on, the switcher will initialize into a
defined default state. This default state may be either a user-
defined default or a GVG factory default of switcher enabled
levels, as selected in the Define Defaults Menu (see Section 3,
Model 2200 Operation Reference manual).
Software Setup
The system parameters to be used at your site are usually
configured following installation of the equipment. Use the
following procedures to configure the 2200 system to your
installation. In addition to assigning sources, the process includes
setting configuring inputs, output levels, external interfaces, and
system parameters. These functions are accessed via the Control
Panel Configuration Menu sub-menus (see Figure 2-1., Parts 1
through 3).
The Configuration Menu
The Configuration Menu is a top-level menu which provides
access to the User Preferences, System Parameters, Inputs,
Outputs, External Interface, and Aux Bus Formats sub-menus.