Filter
Top Products
4-85
Floppy Disk Drive Operations
b. Press the NAME FILE button to complete this menu and
invoke the Name File Menu.
3. In the Name File Menu, select the characters “Effect1” in the
File Name box, then press the ACCEPT NAME button. (A
maximum of eight characters may be used.)
4. Confirm the name with a “Yes,” when the Confirm File Save
Menu displays. The system automatically appends an
extension to the filename, for example, “.R23” for register 23.
Store and Name A Configuration File
In this section you will store and name a configuration setup file
in the “Config” subdirectory.
1. From the Disk Menu, use the FILE SELECT soft knob to
highlight the “Config” subdirectory. (Note: For this
example/scenario, this is where you want to place all your
configuration setup files.)
2. Invoke the Save File Menu (Disk/Save_File).
a. Use the
SAVE SELECT soft knob to select CONFIG. You can
select any combination of the six switcher parameters
listed at the bottom of the menu to SAVE or NO SAVE. To
include all switcher configuration data, select SAVE for all
six parameters listed.
b. Press the NAME FILE button to complete this menu and
invoke the Name File Menu.
3. In the Name File Menu, select the characters “Config1” in the
File Name box, then press the ACCEPT NAME button. (A
maximum of eight characters may be used.)
4. Confirm the name with a “Yes,” when the Confirm File Save
Menu displays. The system automatically appends a “CFG”
extension to the filename; for this example, “Config1.CFG.”