Filter
Top Products
4-60
Section 4— Switcher Operations
Run through the following steps to see how to manipulate
timelines.
1. Recall the previous effect from the E-MEM register. Display
the Timeline Menu.
The display shows the current position in the effect. A cursor
(called the ‘time cursor’) shows the current time position.
2. To change the duration of keyframe 1:
a. Position the cursor at keyframe 1. Press KF DUR.
b. Enter a new time of 3 seconds – press ‘3’ on the E-MEM
Keypad. Press ENTER.
c. Press MOD.
3. To change the duration within an effect (not on a keyframe):
Press GO TO TIME. On the E-MEM Keypad enter a time of 2
seconds, 15 frames, and 1 field. Type: 2 ‘dot’ 15 ‘dot’ 1, ENTER.
(You can enter times in seconds, frames, and fields, or just
frames. Both frame and field numbers must be preceded by
the ‘dot.’) If you entered the above time, the LED readout
would indicate:
002: 15. 1