Filter
Top Products
2-49
Software Setup
For Kaleidoscope:
1. Set the DPM TYPE to KSCOPE.
2. Turn the VIDEO DELAY soft knob to select 2 FIELDS. It is important
to set this delay correctly.
3. Turn the CONTROL DELAY soft knob to select 6 FIELDS.
4. Press the PORT ASSIGN button to assign PORT A1 to the DPM.
The baud rate for Port A1 is fixed at 307 K baud.
5. Set CHANNEL ROUTING for BOTH or SWR IN, depending upon your
system configuration, as described previously under “DPM
Configurations.”
6. Reset the Control Processor in the Model 2200 Signal
Processor frame. This is done by opening the front door of the
Processor and pressing the RESET button located near the
top of the Control Processor module.
Communication should now be established between the Model
2200 and Kaleidoscope.
For Krystal:
1. Set the
DPM TYPE to KRYSTAL.
2. Turn the VIDEO DELAY soft knob to select 2 FIELDS. It is important
to set this delay correctly.
3. Turn the CONTROL DELAY soft knob to select 6 FIELDS.
4. Press the PORT ASSIGN button to assign PORT A1 to the DPM.
The baud rate for Port A1 is fixed at 307 K baud.
5. Set CHANNEL ROUTING for BOTH or SWR IN, depending upon your
system configuration, as described previously under “DPM
Configurations.”
6. Reset the Control Processor in the Model 2200 Signal
Processor frame. This is done by opening the front door of the