Filter
Top Products
2-60
Section 2— Startup and Configuration
Select the desired switcher peripheral port BAUD rate
and parity parameters. These should be set the same for
the switcher and the peripheral device. For a DPM-700 set
the baud rate to 38400 and parity to NONE.
Assigning Peripheral Trigger
Use this menu to delegate any of the eight peripheral triggers for
the switcher (designated A through H) to an E-MEM level of MISC,
or DPM 1–DPM 4. Use the LEVEL soft knob to select which E-MEM
level will activate the selected trigger. Each trigger is sent to a
particular address (Device Number) on the Peripheral Bus.
Once configured, these triggers can be learned into E-MEM effects
(on the MISC level) or fired directly from this menu. Refer to the
Keyframe/Attach Peripheral Trigger Menu description in the
Operation Reference book for attaching peripheral triggers to
E-MEM registers.
PERIPHERAL INTERFACE MENU
EVEN19200
config/extern if/peripheral if
PERIPHERAL
TRIGGERS>
NONE38400
BAUD PARITY
9600
4800
2400
ODD
NOTE:
The Peripheral Bus port is labelled
"Port A3" on the rear of the frame
electronics.