Filter
Top Products
2-40
Section 2— Startup and Configuration
Setting Editor Port Parameters
The Editor Interface Menu shown below allows you to set the
Baud, Parity and Switcher Address for the switcher editor port, J3,
on the Com I/O Module in Slot C1.
1. Select the desired switcher editor port BAUD rate with the
BAUD button. The choices are listed below:
■ 2400
■ 4800
■ 9600
■ 19200
■ 38400 (Typical setting for Grass Valley editors.)
2. Select the desired parity for the switcher editor port with the
PARITY button. The choices are listed below:
■ ODD (Typical setting for Grass Valley editors.)
✮ EVEN
✮ NONE
EDITOR INTERFACE MENU
EVEN19200
config/extern if editor if
NONE38400
BAUD PARITY
9600
4800
2400
ODD
SWITCHER ADDRESS
= 30 hex